How Quickly Does a U-Bend Warm Up? Comparing Five Cases with Python CFD

Simulated air temperature in the standard and shorter U-bends at the same instant. Uncategorized

Hi, Higashi here.

In my last simulation, I heated the air entering a U-bend from 300 K to 350 K, then brought it back down to 300 K. By the time the inlet air started cooling, the air at the outlet was still warming up.

This time I used the same Python CFD solver to vary the length of the duct, the speed of the incoming air and its temperature. I ran five cases and lined them up so we can see what each duct looks like at the same instant. I covered the original setup and how the solver calculates temperature in the previous post on tracking a heat pulse through a U-bend.

Sponsored Links

What happens to the flow path if we move the bend 12 mm closer?

The duct has a square cross section, 6 mm on each side. In the animation, air enters at the lower left, turns around on the right and leaves at the upper left. For the shorter duct, I moved the bend 12 mm closer to the inlet. That takes 12 mm off each leg, so the distance along the centerline from inlet to outlet drops from 69 mm to 45 mm. Both ducts have the same inlet and outlet positions, the same cross section and two right-angle turns.

Case Path length Peak inlet speed Peak inlet temperature
A. Baseline 69 mm 2 m/s 350 K
B. Shorter duct 45 mm 2 m/s 350 K
C. Half the inlet speed 69 mm 1 m/s 350 K
D. Half the inlet temperature rise 69 mm 2 m/s 325 K
E. All three changes 45 mm 1 m/s 325 K

All five ducts start with still air at 300 K. Over the first 0.10 s, the inlet speed and temperature rise to the values in the table. Over the next 0.10 s, they fall back to 0 m/s and 300 K. Five cycles take exactly one second. The outlet is at atmospheric pressure, and the walls are insulated with a no-slip boundary condition. I used the same RNG k–ε turbulence model as before. Heat is carried by the airflow and spreads by diffusion. Air density and the other fluid properties stay constant.

With a grid spacing of 0.5 mm, the standard duct has 19,872 fluid cells and the shorter duct has 12,960. I used a time step of 0.00004 s and saved the flow and temperature fields every 0.01 s. With several cases running in parallel, each took between 1 min 30 s and 2 min 29 s, including mesh setup and saving the results. In all five cases, the heat that entered minus the heat that left matched the energy stored in the air inside the duct.

Sponsored Links

Air speed and temperature in the five cases

Five U-bend simulations at the same instant, with air speed on the left and temperature on the right.
Air speed is on the left and temperature is on the right. The color scales are the same for all five cases. One second of simulated flow plays back in about ten seconds.

Compare the ducts at the same instant and you can see how much the warm-up pattern changes with the duct length and inlet conditions.

Mean air temperature just upstream of the outlet. Each panel compares one of cases B through E with the baseline.
Mean air temperature just upstream of the outlet over the first two cycles. The dashed line is the baseline (A) and the solid line is the case shown in each panel.

In the next post, I’ll use the results from these five simulations to build an AI model.

コメント